Roofing can be an intimating task for many but following the proper steps can help you for removing asphalt shingles in a quick way. Laying new shingles requires tearing off old roofing. You can a large amount of money by tearing out shingles by your own efforts for protecting your house from any kind of rain or other damages.
Make Preparation for Tearing Off Shingles:
Preserving landscape is very necessary for which you need to need a trash container to put all kind of trash of shingles. Wear the safety harness and rubber-soled shoes before starting your work for ensuring protection. See the below area where you want to nail the roof jacks by first stripping. Buy a 2×10 board and keep the space of 4ft for the next step. Use 16d nails for fastening the nails from driving them in roof sheathing into roof beam.
Strip the Shingles of Roof:
You have to split off the ridge caps and fork that are the underside of the shingles by starting at the peak of the roof. Use a notched roofing shovel for splitting off all the top courses of shingles and ridge caps of a roof by prying them loose. They will slide down towards the direction of roof jacks. Carrying them towards the edge of house roof and throwing directly is also a good option. Remove shingles by sliding the fork seen under the shingles and prying the shingles towards the upside. Continue the process of tearing out the shingles until you see roof jacks. It will give you a sign of starting your work at the top of the house roof.
Toss Directly from Roof to the Garbage Container:
Shingles can pile up at the roof jack once you start peeling them so you need to throw them directly in the container for disposing of them. Keep in consideration that shingles are heavy in weight so you need to tear shingles in pieces for protecting yourself from danger. You can also roll the shingles for handling them.
Work Carefully around Roof Penetration:
Evaluating whether you need to reuse the existing flashing can save your money. Save the flashing for reusing them if they are in a good condition so you have to be very careful while working next to exterior walls and skylight. If the roof has metal flashing or there are cracks in metal then it is more suitable to replace it. You can keep working by removing nails and bending them upward off the shingles with the use of pry bar. It will keep the existing flashing safe.
Split off Shingles along the Roof’s edge:
You can strip the edges of your roof with using the fork. Start losing shingles by removing the roof jacks. Prying freely the remaining courses can make them slide off the roof. Use your hands for pulling the shingles and put them in a trash container. Scrap asphalt membrane and pull them out with a fork then install new underlayment over if it does not loosen up.
Take Away Vent Flashing:
There is no worth of old valley flashing so it is better to remove them rather than reusing. Use a fork for prying the vent flashing. Replace it with new vent flashing. Cleaning roof would make it much easier for you to work as you would be able to avoid falls and slips on the floor.
Cover the Roof:
Buttoning up roof by covering an end of the roof with self-sticking ice and water barrier is a last and important step. Track all the section along chalk line by lifting up the bottom part of the barrier. Peel off the backing by allowing falling of barrier in the right place. If you are facing problems while tearing off your old roof panels then you may need to contact professional Roofing contractors Plymouth Michigan for assistance.
April 13, 2017